This amazing kit swaps out the wire turn - handle in your Kinetic Creature with an electric motor. Now, your creation can walk all by itself! It's a one - size - fits - all solution for all kinetic animals. Just a bit of superglue is needed to get it all set up. The Motor Kit includes a 100:1 gear motor, 12 laser - cut wooden gears and a frame, a brass axle, and an AAA battery case with an on/off switch. You'll need 2 AAA batteries and superglue to use it. It's recommended for ages 11 and up because there are small pieces. Remember, it doesn't come with a Kinetic Animal; you have to have one to attach this kit to. Check out a video and instructions here!
Using this motor kit is easy. First, make sure you have a Kinetic Animal to attach it to. Remove the wire turn - handle from your Kinetic Creature. Then, take the parts from the kit. Use superglue to fix the 12 laser - cut wooden gears and the frame in place according to the instructions. Insert the brass axle. Connect the 100:1 gear motor to the gears. Put 2 AAA batteries into the battery case and turn on the on/off switch. Your Kinetic Creature should start walking! Here are some important notes. This kit is for ages 11 and up due to the small pieces, so keep them away from younger kids. When using superglue, be careful not to get it on your skin or clothes. For maintenance, keep the motor and gears clean. If it stops working, check the batteries first to see if they need replacing. If you still have problems, refer to the video and instructions provided.
