Button Switch Sensor Module

This is an amazing push button! It comes with resistors and has a layout that's super friendly to breadboards. When it comes to the push button pinout, the signal goes high when you push the button. It also has positive and ground connections. As for the specifications, it can handle a maximum of 600mW (that's 50mA at 12v).

Using this push - type button switch sensor module is easy. First, connect the positive and ground pins properly to your power source. Then, you can connect the signal pin to your circuit. When you push the button, the signal pin will go high, and your circuit can detect this change. Just be careful not to exceed the maximum power of 600mW (50mA at 12v), or you might damage the module. To keep it in good condition, store it in a dry place and avoid exposing it to extreme temperatures. If you're using it on a breadboard, make sure the connections are firm.