Hey there! Want to take apart that thing over there? With this amazing ratchet screwdriver set, you can handle just about any box or enclosure that needs opening. It's of top - notch quality and great for disassembling and assembling large hardware. It pairs perfectly with our smaller 38 - piece set. What makes this toolbox stand out? It has a wide range of bits, two rubber - handled screwdrivers (one small, one large, non - slippery). The large screwdriver comes with a built - in ratchet. The magnetic bit holder isn't hollow, so no more annoyance of bits falling into the handle. The bits are made of tough CR - V alloy steel, and it all comes in a nice storage box. Each bit is stamped with its name and size. Both handles have extensions to reach tight spots. Here's what's included: Torx bits (T5 - T9 for the smaller handle, T10 - T30 for the larger one), Phillips bits (PH000 - PZ1 for the smaller handle, PH0 - PZ3 for the larger one), Flathead/Slot bits (1.0mm - 4.0mm for the smaller handle, 3.0mm - 7.0mm for the larger one), Hex bits (0.9mm - 2.0mm for the smaller handle, 2.5mm - 6.0mm for the larger one), Square bits (S0.8 - S3), and Sockets (5mm - 13mm).
Using this ratchet screwdriver set is easy. First, pick the right bit for the job from the wide variety in the set. Attach it to the magnetic bit holder on either the small or large screwdriver. If you need to reach a tight spot, use the extension that comes with each handle. When using the large screwdriver, you can take advantage of the built - in ratchet for quicker work. Remember to keep the set in the provided box to avoid losing bits. After use, wipe the bits and handles with a clean cloth to keep them in good condition. Don't use the bits on surfaces harder than the CR - V alloy steel, as this may damage them. If you're not sure which bit to use, refer to the name and size stamped on each bit.
