These hub - mountable aluminum gears are a great choice for transferring motion from a motor or servo to a wheel or shaft. With 76 teeth at a 32P gear pitch, an outer diameter of 2.488 inches, and a 0.50 - inch bore, they use the 0.77 - inch and 1.5 - foot hub pattern. Actobotics is a robotics building system centered around extruded aluminum channels, gears, precision shafts, and ball bearings. Thanks to two standardized hole patterns, almost all Actobotics components can be easily connected. The wide variety of components makes it possible to build complex electromechanical prototypes or finished projects. Dimensions: Teeth - 76T at 32P, OD - 2.488 inches, Bore - 0.50 inches, Hub Pattern - 0.77 inches, 1.5 feet. Documents: SketchUp Part, Product Page (615202).
Using these gears is easy. First, connect the gear to the motor or servo. Then, attach it to the wheel or shaft where you want to transfer the motion. Make sure the holes in the gear match the hub pattern for a proper fit. When handling these gears, be careful not to damage the teeth. If they get chipped or bent, it can affect how well the gear works. For maintenance, keep the gears clean. You can use a soft brush to remove any dirt or debris. Also, check the connection points regularly to ensure they're tight. If you notice any signs of wear, it might be time to replace the gear. This will help keep your robotics project running smoothly.
